Joining contours not working?

Pl
Guest

Joining contours not working? Nov 1, 2020 10:18:29 GMT -5

Hi,

I'm trying to join two existing contours, but still to no avail.

Validation mode also complains of "contour in wrong direction".

Both contours have arrows in counterclockwise (same) directions, but validate tool highlights only the first one.

I'm using Type Light 3.2, may be there are some limitations in the free version.

Starting from scratch is also an option, but I'm wandering is there is a bug, or some undocumented behavior.

Allan Murray Administrator Posts: 419	Joining contours not working? Nov 9, 2020 3:45:41 GMT -5 Select Post Deselect Post Link to Post Back to Top Post by Allan Murray on Nov 9, 2020 3:45:41 GMT -5 In Type light, the only way to connect contours, is to connect the end of one contour to the beginning of another, by drawing a line. The contours must both be open contours.