|
Post by siegbrunn on Nov 14, 2015 10:51:58 GMT -5
I have just edited an OTF font in Type Light 3.2 because the bottoms of all the glyphs were cut off. I discovered the descender was set to "0" (no idea why), so I went into the Font Metrics window and brought the descender down to 300, which was quite sufficient that everything displays beautifully. It displays as well in Windows Fontview and I have already used it in Corel Draw X7 after installing it. So far so good. But while installing it through Font Navigator, I discovered that, although it shows in the font list in Font Navigator, when I choose it, nothing displays. ? I can install it and uninstall it as always, but it's invisible. I changed nothing on the font but the descender. The original font displayed (without the bottom part) just fine in FontNav. Any idea what's going on?
|
|
|
Post by Allan Murray on Nov 17, 2015 4:16:32 GMT -5
Sorry, I am not familiar with Font Navigator - but if you want to send your fonts (modified and unmodified) to me (allanmurray@cr8software.net) then I will check them with a font validator for any problems.
|
|
|
Post by siegbrunn on Nov 18, 2015 4:01:49 GMT -5
Thanks, will do.
|
|