|
|
Post by colawrence on Feb 14, 2013 11:42:44 GMT -5
Is there a way to constrain the movement of nodes or contours to a single direction, ie either up/down or left/right, but not both at the same time? In many programs, this is done by holding down shift, or CTRL, or some other key while mouse dragging, or arrow nudging.
|
|
|
|
Post by Allan Murray on Feb 15, 2013 3:59:23 GMT -5
You cannot constrain the mouse movements, but you can move in a single direction by using the cursor keys (press shift to move faster). Also you can use the move option from the point menu to enter an x or y offset manually.
|
|
|
|
Post by colawrence on Feb 15, 2013 10:05:51 GMT -5
You might seriously consider this capability in a future update.
|
|
